Netbios Use a defined NETBIOS access list or enable name-caching Mtu Set the interface Maximum Transmission Unit (MTU) Ip Interface Internet Protocol config commands End with CNTL/Z.Īrp Set arp type (arpa, probe, snap) or timeoutīandwidth Set bandwidth informational parameterīridge-group Transparent bridging interface parametersĬarrier-delay Specify delay for interface transitionsĭescription Interface specific descriptionĮncapsulation Set encapsulation type for an interfaceĮxit Exit from interface configuration mode I just tried what you suggested and got this response:Įnter configuration commands, one per line. Is anybody able to give me advice on IOS upgrading and understanding the IOS naming structure or point to some on line documents please? Secondly, I have been able to download Switch IOS but not Router IOS (it says I need a valid Contract or something to that effect) does this mean I have to stick with what I have. Processor board ID JAD05240H87 (3259154391)ģ2K bytes of non-volatile configuration memory.ġ6384K bytes of processor board System flash (Read/Write)įirstly, there seems to be a multitude of IOS out there but I am unsure what i need to achieve my aim (maybe IP plus but I don't have enough memory?). System image file is "flash:"Ĭisco 2611 (MPC860) processor (revision 0x203) with 34816K/6144K bytes of memory. ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1) I have a 2611 which I would like to upgrade so that I can use it for VLAN trunking - Here is the sho ver response:Ĭisco Internetwork Operating System Software
0 kommentar(er)
